Enclosure volume for DIY speakers
Drivers need enough air behind them, and the battery and amp take some of it. Measure the inside of the box, then subtract what you put in it.
Calculate it
Internal volume in litres = length × width × height in centimetres ÷ 1000. A box 25 × 17 × 12 cm inside is 5.1 L. In inches, multiply length × width × height by 0.016387. Subtract the battery (a 4S2P 18650 pack is about 0.3 L), the amp and wiring (about 0.1 L), and about 0.15 L per driver magnet. The planner assumes 1.5 L for electronics and wiring, which is conservative, and for molded cases it also applies an 85% usable-volume factor to the published rectangular interior, to allow for ribs, corner radii and draft.
Common case sizes
| Case | Published interior | Usable (× 0.85) | Source |
|---|---|---|---|
| Pelican 1200 | 4.5 L (9.31 × 7.13 × 4.12 in) | 3.8 L | pelican.com |
| M2A1 .50 cal ammo can | 6.9 L (11 × 5.5 × 7 in) | 5.9 L | Common retailer listing; verify your can |
| Pelican 1400 | 8.9 L (11.81 × 8.87 × 5.18 in) | 7.6 L | pelican.com |
| Apache 2800 | 9.3 L (11.88 × 9.00 × 5.31 in) | 7.9 L | DataPro |
| Pelican 1450 | 15.0 L (14.66 × 10.24 × 6.12 in) | 12.8 L | pelican.com |
| Apache 3800 | 15.9 L (14.88 × 10.63 × 6.13 in) | 13.5 L | DataPro |
| Apache 4800 | 23.2 L (17.88 × 12.88 × 6.13 in) | 19.7 L | DataPro |
| Pelican 1550 | 33.4 L (18.63 × 14.18 × 7.72 in) | 28.4 L | pelican.com |
Published litres use the manufacturer’s (or DataPro’s) listed interior length × width × depth. Interiors taper and have corner radii, so measure your own case. Harbor Freight lists the Apache 4800’s inside height as 6-5/8 in, which is a little taller than DataPro’s 6.13 in.
Sealed or ported
Small full-range builds are usually sealed: simpler, tighter bass and less to get wrong. A ported box adds output near its tuning frequency but needs the port length calculated for the box volume and driver.
3D printed enclosures
Print with 4 or more perimeters at 3 to 4 mm wall thickness so the panels don’t resonate. Use PETG or ASA: PLA softens around 55 to 60 °C, which a closed car can reach. Add heat-set inserts for screws, a foam or silicone gasket on the lid, and seal seams so the box is airtight. Large boxes can be split into panels to fit the print bed. Useful items: PETG filament, heat-set inserts.